Description:
AE100 is a quick go tester for relays
that provides you with an indication of the general health and
functioning of the most common Automotive relays. Tester will check for
proper functioning of the relay contacts by connecting the car battery
(11V--15V) to the relay coil. Tester will watch the pin configuration,
the time to contacts closure and opening, consistency of the relay
during each test session. Tester will light the GREEN LED if all passed
during the test session, if not light the RED LED.
Operating Instructions:
1. Connect the power leads to the car
battery -- black alligator clip to negative terminal, red alligator clip
to positive terminal.
2. Tester is powered up when the LED illuminates in RED.
Check the relay before plugging into the
tester. If it’s a 4 pin relay, select “4 pin” on the tester. If it’s a 5
pin relay, select “5 pin” on the tester.
3. Plug in the relay into one of the three receptacles.
Press the “Test” button.
4. Tester will check the pin
configuration of the unknown relay. Tester will light the RED LED if the
unknown relay is not the same to the most of common automotive relays
or the pin of the unknown relay is destroyed.
5. Tester will open and close the relay
10 times for testing the time to contacts closure and opening if the pin
configuration of the relay is right. Tester will light the RED LED
immediately if the time is overtime.
6. Tester will check the consistency of
the relay after testing the time to contacts closure and opening ten
times. Tester will light the GREEN LED if the test passed, if not light
the RED LED.
7. Disconnect power leads from the car battery and remove relay from the tester.
Package Included:
1 X Automotive Relay Tester(JH100)
1 X User Manual
1 X Carry Bag
